Emerson daniel 1500 series - Page 104

Default and user settings (continued)Table 7-3:
Model: S/N: Date:
Parameter Display Default setting User setting
Top display tOP Rate
Bottom display bOtm Total
Advanced features
Total reset t rSt Manual - enable
Grand total reset t rSt Manual - enable
Analog out value A out Rate
Output display 1 dSPL1 0000.0
Output 1 Out 1 4.000
Output display 2 dSPL2 1000.0
Output 2 Out 2 20.000
Scale enable SCALE No - use K-Factor
Scale/Cal # points noPtS 2 (N/A)
Scale unit Funit Pulse/gallon (N/A)
Scale unit time base timE Second (N/A)
Scale/Cal Input 1 InPt 1 00000 (N/A)
Scale/Cal display 1 dSPL1 0000.0 (N/A)
Scale/Cal Input 2 InPt2 1000 (N/A)
Scale/Cal display 2 dSPL2 1000.0 (N/A)
Parameter lock pass-
word
PASS 00000 (unlocked)
Total reset password PASS T 00000 (unlocked)
Grand total reset pass-
word
PASS GT 00000 (unlocked)
Output 1 Out 1 Off
Output 2 Out 2 Off
Low gate LO GATE 1
High gate HI GATE 2
Filter FILTER High speed
Cutoff CUTOFF 0 (disable)
Battery symbol BAT SyM Disable
Modbus slave ID SLV Id 247
Baud rate bAud 19,200 bps
Time delay tdELY 10 ms
Parity PArtY Even
Additional parameters and notes
Startup procedure
92 LTM Internal Display