Emerson daniel 1500 series - Page 23

Default settings for startup (continued)Table 1-7:
Parameter Display Default setting
K - Factor FACTR 1.0000
Rate time base TBASE Second
Rate unit RATEU Gallons/second
Total unit TOT U Gallons
Total multiplier MULT x1
Grand total unit GTOTU Gal
Grand total multiplier MULT x1
Rate decimal point 1111.1 1 place
Total decimal point 111111.1 1 place
Grand total decimal point 111111.1 1 place
Total conversion factor TOTCF N/A (Only valid with custom
units)
Total reset T RST Manual - Enabled
Grand total conversion factor GRTCF N/A (Only valid with custom
units)
Grand total reset T RST Manual - Enabled
Display DSPLY Total
Advanced features
Output variable A OUT Rate
Output display 1 DSPL 1 0000.0
Output 1 OUT 1 4.000
Output Display 2 DSPL2 1000.0
Output 2 OUT 2 20.000.0
Scale/Cal # Points NOPT5 2
Scale/Cal Input 1 INPT 1 00000
Scale/Cal Display 1 DSPL 1 0000.0
Scale/Cal Input 2 INPT2 1000
Scale/Cal Display 1 DSPL2 1000.0
Parameter Lock Password PASS 00000 (unlocked)
Total Reset Password PASS T 00000 (unlocked)
Grand Total Reset Password PASS GT 00000 (unlocked)
Output 1 OUT 1 Off
Output 2 OUT 2 Off
Low Gate LO GATE 1
High Gate HI GATE 2
Filter FILTER High Speed
Introduction
User manual 11