Daniel models 3415, 3416 and 3417 meter specifications (continued)Table 1-1:
Daniel 3415, 3416 and 3417 meter specifications
Note
The process temperature must not exceed the operating temperature range of the transducers.
Note
T-21 and T-41 transducers are used for the direct paths of 16" and larger meters and the reflective
paths of all sized meters. T-22 transducers are used for the direct paths of 12" and smaller meters.
Note
The ultrasonic transducers are not intended for use across boundary walls of different hazardous
area classifications. The transmitter electronics cannot be remote mounted from Division 1 classifi-
cation to a Division 2 area to meet an area classification.
Communications specifications
Connectivity protocols One serial RS-232/RS-485 port (115 kbps baud rate) (Mod-
bus RTU/ASCII)
• (1) Serial Port A
• (RS-232/RS-485 Full Duplex/RS-485 Half Duplex)
One Ethernet Port (TCP/IP) 100 Base
• Up to 10 Mbps (internal connection) 100Mbps (external
connection)
• Modbus TCP, TCP/IP
Device compatibility Daniel Ultrasonic flow meters are compatible with nearly
every commercially available flow computer. Examples: Flo-
Boss 103, FloBoss S600 flow computer, ROC 107.
Digital, analog, and frequency inputs
Digital Input(s) (1) Single polarity
Note
DI1Mode must be set to Digital Input/Calibration Input.
Introduction
Installation manual 17
To Next Page
Loading...
Need help?
General
