CAUTION!
TRIPPING HAZARD
Clear all obstacles or obstructions from the work area when transporting, installing or removing the
meter.
Failure to clear the work area may cause injury to personnel.
WARNING!
CRUSHING HAZARD
Do not remove flange stabilizers.
Attempting to do so may allow the meter to roll, resulting in serious injury or equipment
damage.
A. Flange stabilizers
WARNING!
CRUSHING HAZARD
Before installation, do not rest the meter on a slope of greater than 10 degrees. Also ensure the
surface is solid so that the flange stabilizers do not sink into the surface.
Failure to comply may allow the meter to roll, resulting in serious injury or equipment damage.
CAUTION!
ESCAPING GASES OR FLUIDS HAZARD
The purchaser of the meter is responsible for the selection of Daniel components/seals and materials
compatible with the chemical properties of gas flow measurement.
Failure to select the suitable meter component/seals may cause escaping gases or liquids,
resulting in injury or equipment damage.
Consult your Daniel Sales and Service representative to ensure you purchase the correct
components and seals for your application.
Mechanical installation
24 Gas Ultrasonic Flow Meter
To Next Page
Loading...
Need help?
General
