1592038420 XRB30-60-70-77CH EN v1.1 2021.09.15 XRB 18/38
2nd high temperature alarm
2nd temperature alarm differential
2nd temperature alarm delay
2nd temperature alarm delay at start-up
Compressor OFF due to 2nd low temperature alarm
Compressor OFF due to 2nd high temperature alarm
Relay output oA1 configuration
Relay output oA2 configuration
Relay output oA3 configuration
Relay output oA4 configuration
Base times for digital inputs
Digital input 1 configuration
Digital inputs 1 alarm delay (base time depends on par. ibt)
Digital input 2 configuration
Digital inputs 2 alarm delay (base time depends on par. ibt)
Number of external pressure switch alarms before stopping the
regulation
Compressor and fan status after door opening
Regulation restart after door alarm
Light output activation from door input
Time with light output forced ON (0=function disabled)
Motion sensor detections before activating a light output (valid if ixF=EMt
and MSF=LiG or ALL)
Time with light output forced ON after motion detection
Function linked with the motion sensor
Motion sensor stop reading interval after switching off the light output by
button, serial command or energy saving algorithm (valid if ixF=EMt)
Number of virtual door openings of a single cell for energy saving
activation
Temperature differential in energy saving
Energy saving controls the lights (lights OFF when energy saving goes
active)
Period of analysis for ErA (valid if ErA=Aut)
Number of contiguous cells to activate energy saving (valid if ErA=Aut)
Number of contiguous cells with energy saving for Set-Point variation
(valid if ErA=Aut)
Automatic Pull Down activation after energy saving (1=30min)
Maximum number of consecutives cells with energy saving activated
(valid only if ErA=Aut)
Minimum number of consecutive cells in normal mode (valid only if
ErA=Aut)
System tuning: 0=low sensibility; 1=high sensibility
Temperature probe used by automatic energy saving algorithm (valid if
ErA=Aut)
Force status change from energy saving mode to normal mode (valid if
ErA=Aut)