Set Up I/O Network Quick Start • 10-15
10.13 Set Up I/O Network
Figure 10-22 - Network Setup Menu
To start the setup on the I/O Network, access the Net-
work Setup menu:
1. Press
to open the Main Menu
2. Press
(System Configuration)
3. Press
(Network Setup)
The Network Setup menu displays four options:
• Network Summary
• Connected I/O Boards & Controllers
• Router Setup
• Controller Associations
For the total (E2) devices onl
ine or offline, status,
setup screens, changing board or controller names, config-
uring and commissioning devices, deleting a device, and
view
ing detailed status screens of controllers, select Net-
work Summary.
For the number of I/O Network devices (16AIs,8ROs,
etc.) ass
ociated with each controller online and offline,
select Connected I/O Boards & Controllers.
To set up a router, select Rout
er Setup. For more
information on routers and repeaters, refer to the Router
and Repeater Installation Guide (P/N 026-1605).
For CC-100 circuit associations, select Contr
oller
Associations.
10.13.1 Specify Number of Boards
Specify the number of boards from the Connected I/O
screen:
1. Press
to open the Main Menu
2. Press
(System Configuration)
3. Press
(Network Setup)
4. Press
(Connected I/O Boards & Controllers)
Figure 10-23 - Connected I/O Screen (RX version)
Boards on the I/O Network
16AI Boards Enter the number of 16AI analog
input boards on this E2’s I/O Network.
8RO Boards Enter the number of 8RO relay output
bo
ards on this E2’s I/O Network.
8DO Boards Enter the number of 8DO digital out-
put boards on this E2’s I/O Network.
4AO Boards Enter the number of 4A
O analog out-
put boards on this E2’s I/O Network.
IRLDS Controllers Enter the number of leak detec-
tor units on this E2’s I/O Network.
(Options will vary depending on the type of controller
used.)
10.13.2 Checking Online Status
Figure 10-24 - Network Summary Screen
You can check all boards that are on either the Echelon
Network (E2 controllers) or the I/O Network from the Net-
To Next Page
Loading...
