Emerson E2 - Web Services; Set up Alarming

10-20 • E2 RX/BX/CX I&O Manual 026-1614 Rev 4 5-JAN-2013
Enter your license key to activate the desired feature:
Figure 10-34 - Enter Your Unique License Key
4. Reboot the controller and open the License
Report screen again to see the license key appear
next to the activated feature (Figure 10-35):
Figure 10-35
- License Report Screen
10.15.1 Web Services
Web Services is a licensed feature that allows the user,
once the required license has been obtained and entered, to
view and adjust certain parameters in the E2 controller
through a Web page. The E2 Web Services feature enables
the user to:
• View site-specific information such site nam
e, site
phone, local date and time.
• View the current version of
the E2. This includes
the type of unit (e.g., RX-400) and the version of
the firmware.
• View global data values such as outside air tem-
perature and humidity.
• View a list of other networke
d area controllers at
the site, including version and controller type infor-
mation.
• Connect to the selected E2 for rem
ote configuration
changes.
• Access Terminal Mode.
• View Alarms.
To access Web Services:
Open a browser window and enter the IP Address of
yo
ur E2 controller:
Figure 10-36 - E2 Web Services Page
10.16 Set Up Alarming
To set up alarms, open the Alarm Setup menu:
1. Press
 to open the Main Menu
2. Press
 (System Configuration)
3. Press
 (Alarm Setup)