E2 RX/BX/CX I&O Manual Table of Contents • v
TABLE OF CONTENTS
1 INTRODUCTION...................................................................................................................................................... 1-1
1.1 THE E2 REFRIGERATION CONTROLLER (RX)............................................................................................................ 1-1
1.2 THE E2 BUILDING CONTROLLER (BX)...................................................................................................................... 1-2
1.3 THE E2 CONVENIENCE STORE CONTROLLER (CX)................................................................................................... 1-3
1.4 NETWORKING OVERVIEW.......................................................................................................................................... 1-4
1.4.1 E2 I/O Network .................................................................................................................................................. 1-4
1.4.2 The E2 Echelon Lonworks Network................................................................................................................... 1-5
1.4.3 Interconnection With Other E2s ........................................................................................................................ 1-5
1.5 DOCUMENTATION OVERVIEW ................................................................................................................................... 1-6
1.6 ON-LINE HELP SYSTEM OVERVIEW.......................................................................................................................... 1-7
1.7 SOFTWARE LICENSING............................................................................................................................................... 1-7
2 HARDWARE OVERVIEW...................................................................................................................................... 2-1
2.1 E2 HARDWARE .......................................................................................................................................................... 2-1
2.1.1 E2 Main Processor Board (CPU)...................................................................................................................... 2-2
2.1.2 E2 Processor Interface Board (PIB).................................................................................................................. 2-2
2.1.3 E2 Keypad.......................................................................................................................................................... 2-2
2.1.4 LEDs................................................................................................................................................................... 2-2
2.2 I/O NETWORK BOARDS AND PERIPHERALS............................................................................................................... 2-3
2.2.1 The Gateway Board ........................................................................................................................................... 2-3
2.2.2 MultiFlex Boards ............................................................................................................................................... 2-4
2.2.2.1 MultiFlex 16 Input Board ........................................................................................................................................ 2-4
2.2.2.2 MultiFlex Combination Input/Output Boards.......................................................................................................... 2-4
2.2.2.3 MultiFlex CUB ........................................................................................................................................................ 2-6
2.2.2.4 MultiFlex RTU (BX and CX Only)......................................................................................................................... 2-6
2.2.2.5 MultiFlex Rooftop Control Board (RCB) (BX and CX Only) ................................................................................ 2-6
2.2.2.6 MultiFlex PAK Board.............................................................................................................................................. 2-6
2.2.3 The MultiFlex ESR Board.................................................................................................................................. 2-7
2.2.4 Hand-held Terminal (P/N 814-3110)................................................................................................................. 2-7
2.2.5 The 8RO and 8ROSMT Relay Boards................................................................................................................ 2-8
2.2.6 4AO Analog Output Board................................................................................................................................. 2-9
2.2.7 8DO Digital Output Board and PMAC II Anti-Sweat Controller ..................................................................... 2-9
2.3 ECHELON NETWORK BOARDS AND PERIPHERALS................................................................................................... 2-10
2.3.1 The 16AIe (Discontinued)................................................................................................................................ 2-10
2.3.2 The 8ROe (Discontinued)................................................................................................................................. 2-10
2.3.3 EC-2s................................................................................................................................................................ 2-11
2.3.4 CC-100 Case Controllers and CS-100 Case Circuit Controllers.................................................................... 2-11
2.3.5 TD3 Temperature Display ............................................................................................................................... 2-12
2.3.6 Facility Status Display (FSD).......................................................................................................................... 2-12
3 MOUNTING............................................................................................................................................................... 3-1
3.1 MOUNTING THE E2.................................................................................................................................................... 3-1
3.1.1 Standard Mount.................................................................................................................................................. 3-1
3.1.2 Recessed Mount.................................................................................................................................................. 3-1
3.1.3 Retrofit Mounting............................................................................................................................................... 3-2
3.1.4 Blank Face ......................................................................................................................................................... 3-3
3.2 MOUNTING I/O BOARDS............................................................................................................................................ 3-3
3.2.1 Single/Double Enclosures................................................................................................................................. 3-3
3.2.2 Boards Without Enclosures (Snap Track).......................................................................................................... 3-4
To Next Page
Loading...
