I-2 • E2 RX/BX/CX I&O Manual 026-1614 Rev 4 5-JAN-2013
date and time stamp 12-12
dial-out 10-21
The Alarm Output 10-21
The Display Line 10-21
The Echelon Network 10-21
forced to normal. See Alarms, reset to nor-
mal.
resetting 12-14
reset-to-normal 12-13
return-to-normal 12-13
state, in advisory log 12-12
the Alarm Annunciator 10-21
Alternate I/O Formats 10-27
Analog Sensor Control 11-39
Annunciator Home Screen 10-22
Anti-Sweat
case-controlled 11-13
dewpoint input 11-14
how setpoints work 11-14
how anti-sweat works 11-46
setup 11-46
zones, definition of 11-46
Application Setup 10-25
-B-
BACnet 6-13
E2 Connection 6-14
MS/TP 6-13
Overview 6-13
BACnet IP-based communication 6-14
Base Log Group 11-17
Baud Rates 10-12
E2
RS-232 port 10-12
E2, setting for I/O Network 10-12
I/O Network 6-3
8DO 6-4
8IO 6-4
ARTC 6-4
E2 6-3
IRLDS 6-3
Blue "R". See Cold Reset.
Board Types 6-1
Boards on the I/O Network 10-2, 10-15
Boiler 11-56
Box to Box Communications 7-1
Box-To-Box 1-5
Building Controller 1-2
Buttons
cold reset 10-1
reset 10-1
BX Capabilities 1-2
BX Home Screen 12-1
-C-
Case Circuits, Standard. See Standard Circuits.
Case Control Circuits
associating CC-100s with 11-16
defrost in 11-12
overview 11-10
Case Controllers
anti-sweat control 11-13
associating with Case Control Circuits 11-16
CC-100H
defined 2-11, 11-10
CC-100LS
defined 2-11, 11-10
CC-100P
defined 2-11, 11-10
CCB 9-18
clean mode 11-14
CS-100
defined 2-11, 11-10
defrost 11-12
pump down delay 11-12
defrost types 11-12
digital sensors
installing 9-16
dual temp control 11-14
EEPRs
recovery mode 11-12
fail-safe mode 11-15
fan control 11-14
humidity sensor installation 9-16
inputs 9-16
installation guide 8-6
light control 11-14
mounting dimensions 3-5
power modules
wiring 9-17
wiring schematic 9-17
problems with cases F-6
recovery mode
EEPRs 11-12
To Next Page
Loading...
Need help?
General
