I-8 • E2 RX/BX/CX I&O Manual 026-1614 Rev 4 5-JAN-2013
manual entry of 10-18
No Description File 8-5
Noise Minimization 6-3
-O-
Off-Cycle Defrost. See Defrost, off-cycle.
Open Echelon 8-4
Operator’s Guide to Using the E2 12-1
OSS. See AHUs, optimum start-stop.
Outputs
digital
selecting units 9-14
Outside Temperature Sensor. See Sensors, out-
side temperature.
Overrides
initiating 12-10
-P-
PAK 2-6, 11-31
Part Numbers and Model Descriptions 2-1
Passwords
setting 10-13
Peer Communications 7-1
closed network layout 7-2
ethernet IP configurations 7-1
ethernet network layouts 7-2
hardware specifications 7-1
open network layout 7-2, 7-3
software specifications 7-2
troubleshooting 7-4
PIB 2-2
PID Control D-1
Plus Board 6-2
PMAC II
defined 2-9
Pointers
input and output 12-16
Points. See Inputs or Outputs.
Power
I/O Boards 6-5
Power Modules
wiring 9-17
wiring schematic 9-17
Power Monitoring 11-44
daily logs 11-45
hourly logs 11-45
logging 11-45
monthly logs 11-45
shed mode 11-44
Pressure Transducers 3-7
Pulse Accumulation 11-50
accumulator reset types 11-51
configuration 11-50
high trip 11-51
logging 11-51
outputs 11-50
Pulse Modulating Anti-Sweat Controller. See
PMAC II.
Pulsed Defrost. See Defrost, pulsed.
-R-
RCB 2-6, 11-26
Recovery Mode, for Case Controllers 11-11
Refrigeration Controller 1-1
Relay Output Test Mode 9-11
Repeaters
part number for manual 1-6
two-channel
mounting 3-6
Reset Button 10-1
Resetting 12-14
Resetting the E2 Controller 10-1
Retrofit Mounting 3-2
Returned-To-Normal and Forced-To-Normal
Alarms 12-12
Reverse Cycle Hot Gas. See Defrost, reverse cy-
cle hot gas.
RLDS 6-11
Diagnostic Alarm 6-12
RMS 11-57
RMS Asset 11-57
RMS Scale 11-57
Rotary Dials
I/O Board Settings 6-3
Settings For 8IO 6-3
Routers
part number for manual 1-6
RS-232 Baud Rate 10-12
RS485 Network
I/O Network 6-1
noise minimization 6-3
RTU 2-6, 11-26
RX Capabilities 1-1
RX Home Screen 12-1
To Next Page
Loading...
Need help?
General
