Emerson Keystone EPI2 63 - Actuator Configuration

Installation, Operation and Maintenance Manual
MAN-10-04-100-0711-EN Rev. 0
October 2020
27
Actuator Conguration
Section 6: Actuator Conguration
Section 6: Actuator Conguration
Before connecting power to the actuator, check that the voltages are correct and
according to the indications on the nameplate. Wrong power supply could cause
permanent damage to the electrical components.
The conguration of the Keystone EPI2 actuator can be carried out through the control
panel inside the actuator control system. To access the panel, remove the actuator cover
and when the conguration is complete replace the cover, following the procedures
indicated on next page.
NOTE
When optional local control panel OM3 is installed and the actuator setting is done by means
of the pushbuttons on the logic board, the remote controls do not have to be energized.