October 2020
Installation, Operation and Maintenance Manual
MAN-10-04-100-0711-EN Rev. 0
20
Installation
Section 4: Installation
4.10 Cables Connections
Before applying voltage to the Keystone EPI2 check that the electrical parameters
(supply voltage and current) shown on the nameplate and on the attached wiring
diagram are correct for the installation.
Figure 10 Overview of the Electrical Connections
!
WARNING
Do not remove earth connection X while connecting the actuator to plant earthing.
NOTE
All the accessories which equip the Keystone EPI2, in particular the cable glands, must be
certied according to the Standard Directive and specic Rules applying to the products.
To Next Page
Loading...
