Emerson Keystone EPI2 63 - 3-WIRES;2-WIRES Remote Control Configuration; Configuration of the Keystone EPI2 by a PDA; PC and A Manager Software

October 2020
Installation, Operation and Maintenance Manual
MAN-10-04-100-0711-EN Rev. 0
38
Actuator Conguration
Section 6: Actuator Conguration
6.2.15 3-WIRES/ 2-WIRES Remote Control Conguration
Remote Control in 3-WIRES conguration works as follow: command on terminal 35 to OPEN,
command on terminal 36 to CLOSE. Remote Control in 2-WIRES conguration works as
follow: command present on terminal 35 to OPEN, command absent on terminal 35 to CLOSE;
terminal 36 not used. As default, remote command parameter is congured as 3-WIRES.
To congure Remote Control parameter:
• Enter set up conguration: move switch SW3 to position ON (conguration function)
• Move switch SW4 to position 9
• Move switch SW6 to position 5 (3-WIRES) or 6 (2-WIRES)
• Conrm by pushing ENTER pushbutton SW5
• When pushing SW5, the red LED switches on for conrmation
• Exit set up conguration (move switch SW3 to position 1) or proceed with
the next parameter
6.3 Conguration of the Keystone EPI2 by a
PDA / PC and ‘A Manager’ Software
If one of the optional module OM1, OM9 or OM11 is installed on the Keystone EPI2 and
this card features Bluetooth interface, the actuator conguration can be performed by
means of the ‘A Manager’ software installed on the PDA or PC.
Only Blinker/ Local Selector relay and heater cannot be congured by means ‘A Manager’
software. The relevant Instruction and Operating Manual is available with the
‘A Manager’ software.
!
WARNING
The controls available via Bluetooth allow full actuator operability at a distance.
Emerson will not accept any responsibility for damages or injuries caused by an improper
use of your Bluetooth PDA.