Emerson Keystone EPI2 63 - Removal of the Control Unit Cover

October 2020
Installation, Operation and Maintenance Manual
MAN-10-04-100-0711-EN Rev. 0
28
Actuator Conguration
Section 6: Actuator Conguration
6.1 Removal of the Control Unit Cover
Using a 5 mm Allen key, loosen the four screws and remove the cover.
NOTE
When setting the actuator parameters do not operate the actuator neither remotely nor locally.
!
WARNING
Pay attention not to damage the joint surfaces of the cover.
NOTE
In case the screws of the cover must be replaced, SS Class A4 grade 80 screw must be used
with minimum yield strength 600 N/mm
2
.
Once the conguration is completed, reassemble the actuator cover.
Figure 14 Removal of the Control Unit Cover