Emerson Keystone EPI2 63 - Page 34

October 2020
Installation, Operation and Maintenance Manual
MAN-10-04-100-0711-EN Rev. 0
30
Actuator Conguration
Section 6: Actuator Conguration
Figure 15 Conguration of the actuator parameters
Table 5. Set-up Base Card
Set-up
Rotary switches position Dip switch Enter button
Default
SW4 SW6 SW3 SW5
Close limit 0 0 ON PUSH n.d.
Open limit 1 0 ON PUSH n.d.
L/S close
2 1: by position ON PUSH
1
2 0: by torque ON PUSH
L/S open
3 1: by position ON PUSH
1
3 0: by torque ON PUSH
Closing speed
4 4 ON PUSH
64 6 ON PUSH
4 8 ON PUSH
Opening speed
5 4 ON PUSH
65 6 ON PUSH
5 8 ON PUSH
% Closing
torque
6 2: 50% ON PUSH
96 5: 75% ON PUSH
6 9: 100% ON PUSH
% Opening
torque
7 2: 50% ON PUSH
97 5: 75% ON PUSH
7 9: 100% ON PUSH
CW/CCW
8 0: CW; ON PUSH
0
8 1: CCW; ON PUSH
Size
9
0: 63 Nm / 250 Nm ON PUSH
0
9
1: 125 Nm / 500 Nm ON PUSH
9 3: 1000 Nm ON PUSH
9 4: 2000 Nm ON PUSH
Nm / in-lb
0 8: Nm ON PUSH
8
0 9: in-lb ON PUSH
Blinker /
Local Selector
4 0: Off ON PUSH
04 1: Blinker ON PUSH
4 2: Local Selector ON PUSH
Heater
8 9: Active ON PUSH
9
8 8: Not active ON PUSH
Inversion
colours LED of
local control
9 2 ON PUSH
LED Open: Green
LED Close: Red
Remote
control
9
5 = 3 wires
ON PUSH 5
6 = 2 wires