October 2020
Installation, Operation and Maintenance Manual
MAN-10-04-100-0711-EN Rev. 0
46
Parts List and Drawings
Section 9: Parts List and Drawings
Table 9. Keystone EPI2 Model 063 - General Assembly
* Indicates recommended spare parts
Pos. Description Quantity
1 Nut UNI 5588-M6 2
2 Nut UNI 5588-M8 2
3 Eccentric 1
4 Planocentric gear 2
5 Spacer 1
6 Ball bearing type 16002 1
7 Ball bearing type 16004 2
8 Ball bearing type 6001 1
9 ESH screw UNI 5931-M6x8 1
10 HSHC screw UNI 5931-M6x16 4
11 HSHC screw UNI 5931-M4x14 7
12 HSHC screw UNI 5931-M6x18 2
13 HSHC screw UNI 5931-M6x25 4
14 HSHC screw UNI 5931-M8x20 4
15 HSSC screw UNI 5933-M4x10 1
16 Cover assembly 1
17 Drive and control unit 1
18 Handwheel 1
19 Output drive assembly 1
20 Standard housing 1
21 Stopper 2
22 Terminal block 1
23 Worm shaft ange 1
24 Anti-loosening washer UNI 8842-J6 1
25 Base plate ISO 5211 / F05-F07 1
26 Cover gasket 1*
27 Dowel pin UNI EN 22338 1
28 Earth stud 1
29 Fixed anulus 1
30 Gasket 1*
31 Indicator 1
32 Indicator shaft 1
33 Manual worm shaft 1
34 Motor pinion 1
35 O-ring Di=10.77/W=2.62 1*
36 O-ring Di=18.77/W=1.78 1*
37 O-ring Di=52.07/W=2.62 1*
38 O-ring Di=6.07/W=1.78 1*
39 Plug 1
40 Position label 1
41 Power clamps protection 1
42 Ring 2
43 Ring for pins alignement 1
44 Ring RW 7 UNI 7433 2
45 Seal washer 8.3 2
46 Sliding ring 1
47 Snap ring for shaft D.6 1
48 Terminal block cover 1
49 Terminal board gasket 1*
50 Wheel 1
To Next Page
Loading...
