October 2020
Installation, Operation and Maintenance Manual
MAN-10-04-100-0711-EN Rev. 0
50
Parts List and Drawings
Section 9: Parts List and Drawings
Table 11. Keystone EPI2 Model 250 - General Assembly
* Indicates recommended spare parts
Pos. Description Quantity
1 Nut UNI 5588-M12 2
2 Nut UNI 5588-M6 2
3 Eccentric 1
4 Planocentric gear 2
5 Spacer 1
6 Ball bearing type 6005 2
7 Ball bearing type 6202 1
8 Ball bearing type 16002 1
9 ESH screw UNI 5931-M6x8 1
10 HSHC screw UNI 5931-M6x16 4
11 HSHC screw UNI 5931-M10x25 4
12 HSHC screw UNI 5931-M4x14 7
13 HSHC screw UNI 5931-M6x20 2
14 HSHC screw UNI 5931-M6x25 4
15 HSSC screw UNI 5933-M4x10 1
16 HSSC screw UNI 5933-M5x12 3
17 Cover assembly 1
18 Handwheel 1
19 Housing 1
20 Motor pinion 1
21 Output drive assembly 1
22 Stopper 2
23 Terminal block 1
24 Anti-loosening washer UNI 8842-J6 2
25 Base plate ISO 5211 F07-F10-F12 1
26 Cover gasket 1*
27 Dowel pin UNI EN 22338 1
28 Earth stud 1
29 Fixed anulus 1
30 Gasket 1*
31 Indicator 1
32 Indicator shaft 1
33 Manual worm shaft 1
34 O-ring Di=10.77/W=2.62 1*
35 O-ring Di=18.77/W=1.78 1*
36 O-ring Di=6.07/W=1.78 1*
37 O-ring Di=69.52/W=2.62 1*
38 Plug 1
39 Position label 1
40 Power clamps protection 1
41 Ring 1
42 Ring for pins alignement 1
43 Ring RW 10 UNI 7433 2
44 Seal washer 12.3 2
45 Sliding ring 1
46 Snap ring for shaft D.12 1
47 Terminal block cover 1
48 Terminal board gasket 1*
49 Wheel 1
50 Worm shaft ange 1
51 Drive and control assembly 1
To Next Page
Loading...
