UPS System: HIPULSE E
Communication System Manual
Description of Protocol (Modbus/Jbus Interface)
Page 5-4
(04/07)
5.3.3 Commands entered with the Operator Panel
This section describes all requests and commands which may be entered with the Operator Panel, specifying syntax and
response.
The following requests and commands are available:
a) Panel configuration request Function 03 Read Holding Register
b) Panel date and time request Function 03 Read Holding Register
c) Request for UPS alarm status Function 03 Read Holding Register
d) Request for values of current UPS measurements Function 03 Read Holding Register
e) Request for UPS programming settings Function 03 Read Holding Register
f) Request for Alarm History Function 03 Read Holding Register
g) UPS Alarm History command Function 06 Write Single Register
h) UPS functional command Function 06 Write Single Register
i) Date and time setting command Function 06/16 Write Single/Multiple Register
Note: The same commands\requests apply to UPS system configuration with MSS.
To Next Page
Loading...
Need help?
General