Communication System Manual
UPS System: HIPULSE E
(Modbus/Jbus Interface)
(04/07)
Page iii
IMPORTANT
This manual contains information on interfacing with a Building Management System (BMS)
using the Modbus/Jbus protocol
for use with Single module or 1+N System HIPULSE E UPS (from 16.1 to 19.1 SW release )
or Multi-ModuleUnit with external MSS (up to 7.0 SW release ).
Read this manual right through
before beginning installation work.
The UPS must be commissioned and serviced by an engineer approved by the manufacturer (or his agent).
Failure to do could result in personnel safety risk, equipment malfunction and invalidation of warranty
If you encounter any problems with the procedures contained in this manual you should seek immediate assistance
from the EMERSON Sales Office from whom the equipment was purchased. Alternatively, contact the Customer
Service & Support department at the address shown below:
Emerson Network Power Ltd - United Kingdom
Customer Service and Support Department
Fourth Avenue, Globe Park
Marlow
Buckinghamshire SL71YG
United Kingdom
Telephone +44 1628 40 32 00
Fax +44 1628 40 32 03
Emerson Network Power, Services Dpt.
Customer Service and Support Department
Via Leonardo da Vinci 8
35028 - Piove di Sacco (PD)
Italy
Help Desk Telephone +39 049 9719311
Fax +39 049 9719053
support.serviceemea@emersonnetworkpower.com
Please visit our web site: http://www.eu.emersonnetworkpower.com
While every precaution has been taken to ensure accuracy and completeness in this manual, Liebert
Corporation assumes no responsibility and disclaims all liability for damages resulting from use of this
information or for any errors or omissions.
Liebert Corporation pursues a policy of continual product development and reserves the right to change the
equipment design without notice.
Copyright 2007 by Liebert Corporation.
Unauthorized reproduction prohibited
All rights reserved.