260 Micro Motion Series 1000 and Series 2000 Transmitters
NE53 History
12/2001 3.x Software expansion 3600647 B
3600785 A
20000325 A
20000325 B
20000150 A
20000150 B
20000148 A
Added support for the configurable I/O option board
Software version information available via the display or Modbus
Configurable density cut-off
Additional HART variables can be assigned to QV
The display start/stop totalizers function can be enabled or disabled
Petroleum measurement application improvements
Live zero available as display variable
Increased options for fault output settings
New cryogenic application temperature algorithms
Software adjustment
Improved frequency output stability and unit conversions
Improved the handling of volume flow rate when slug flow is detected
Improved handling of density values and calibrations during fault
conditions
Display configuration, screen flow and optical switch changes
HART communication and burst mode improvements
Feature addition
Petroleum measurement application added
Custody transfer option added to Configurable I/O option board
HART polliing for external pressure/temperature added
06/2003 4.x Software expansion 20000325 C
20000150 C
3600647 C
20000148 B
20001715 A
Added support for the Model 1500 transmitter
Increased variables displayed by the Model 1700
Software adjustment
Improved the handling of certain alarm conditions
Clarified the behavior of certain Modbus calibration coils
Clarified the interaction between certain density measurement units
and density cutoff values
Improved the handling of the mA source setting via the display
Improvements to pressure and temperature polling
HART Tri-Loop and other communication improvements
Clarified the value returned by Modbus scaled integer registers during
a fault condition
Feature addition
Discrete values now available through Modbus
Table I-1 Transmitter software change history continued
Date
Software
version
Changes to software
Operating
instructions
To Next Page
Loading...
