Emerson Micro Motion 1000 Series

Configuration and Use Manual 51
Required Transmitter Configuration
Required Configuration Optional ConfigurationUsing the TransmitterFlowmeter Startup
6.4.3 Density units
The default density measurement unit is
g/cm3. See Table 6-2 for a complete list of density
measurement units.
6.4.4 Temperature units
The default temperature measurement unit is
degC. See Table 6-6 for a complete list of temperature
measurement units.
SLPH SLPH Not available Standard liter per hour
SLPD SLPD Not available Standard liter per day
SPECL special Spcl Special unit (see Section 8.5)
Table 6-5 Density measurement units
Density unit
Unit descriptionDisplay ProLink II Communicator
SGU SGU SGU Specific gravity unit (not temperature corrected)
G/CM3 g/cm3 g/Cucm Grams per cubic centimeter
G/L g/l g/L Grams per liter
G/mL g/ml g/mL Grams per milliliter
KG/L kg/l kg/L Kilograms per liter
KG/M3 kg/m3 kg/Cum Kilograms per cubic meter
LB/GAL lbs/Usgal lb/gal Pounds per U.S. gallon
LB/CUF lbs/ft3 lb/Cuft Pounds per cubic foot
LB/CUI lbs/in3 lb/CuIn Pounds per cubic inch
D API degAPI degAPI API gravity
ST/CUY sT/yd3 STon/Cuyd Short ton per cubic yard
Table 6-6 Temperature measurement units
Temperature unit
Unit descriptionDisplay ProLink II Communicator
°C degC degC Degrees Celsius
°F degF degF Degrees Fahrenheit
°R degR degR Degrees Rankine
°K degK Kelvin Kelvin
Table 6-4 Volume flow measurement units – Gas continued
Volume flow unit
Display ProLink II Communicator Unit description