Emerson Micro Motion 1700 - Page 322

H
HART
address 103, 107, 195
burst mode 104, 196
device description (DD) 277
HART/Bell 202
configuring 103
Field Communicator connections 278
HART/RS-485
configuring 107
loop 194
Loop Current Mode 103, 195
variables
configuring 105
interaction with transmitter outputs 106
options 106
hysteresis 96
I
I/O terminals 306
informational parameters 76
installation types
4-wire remote 301
9-wire remote 301
high-temperature flexible conduit 301
integral 301
remote core processor with remote transmitter 301
inventories
resetting 131
starting and stopping 128
L
language
for display 59
Last Measured Value Timeout, See Fault Timeout
LD Optimization 154, 156, 157
LED, See status LED
local display, See display
Local Operator Interface (LOI), See display
Loop Current Mode 103, 195
loop testing
using ProLink II 190
using ProLink III 191
using the display 188
using the Field Communicator 192
Lower Range Value (LRV) 83
M
mA outputs
Added Damping
configuring 86
interaction with density damping 50
interaction with flow damping 27
AO cutoff
configuring 85
interaction with volume flow cutoff 33
configuring 82
Fault Action
configuring 88
options 88
loop testing
using ProLink II 190
using ProLink III 191
using the display 188
using the Field Communicator 192
Lower Range Value and Upper Range Value
configuring 83
default values 84
process variable
configuring 82
options 83
scaling 83
troubleshooting 184, 196
mass flow measurement
configuring 23
cutoff
configuring 27
effect on volume measurement 28
interaction with AO cutoff 28
flow damping 26
measurement units
configuring 23
options 24
meter factor 152
troubleshooting 180
Maximum Pulse Width 92
measurement units
density
configuring 46, 48
options 46
gas standard volume flow rate
configuring 36
options 36
special unit 37
mass flow rate
configuring 23
options 24
special unit 25
Index
314 Micro Motion
®
Model 1700 Transmitters with Analog Outputs