• Prepare the 9-wire cable as described in the Micro Motion 9-Wire Flowmeter Cable
Preparation and Installation Guide.
• Connect the cable to the sensor-mounted core processor or junction box as described
in the sensor documentation. You can access all product documentation on the
documentation DVD shipped with the product or at www.emerson.com.
Procedure
1. Remove the transmitter-to-sensor wiring compartment cover to reveal the terminal
connections.
Figure 3-8: Removal of the transmitter-to-sensor wiring compartment cover
2. Feed the sensor wiring cable into the transmitter wiring compartment.
Figure 3-9: Sensor wiring feedthrough
3. Connect the sensor wires to the appropriate terminals.
Mounting and sensor wiring Installation Manual
February 2020 MMI-20027478
16 Micro Motion 5700 Transmitters with Configurable Outputs
To Next Page
Loading...
