EMKO EAOM-19 User Manual

11
OperatingTemperature:
Max.OperatingHumidty :
Altitude :
-25°Cto+70°C
90Rh(non-condensing)
Upto2000m.
%
OperatingConditions
Forbidden Conditions:
Corrosive atmosphere
Explosive atmosphere
Home applications (The unit is only for industrial applications)
2.4EnvironmentalRatings
2.5PanelMounting
c
c
1
2
3
1-Before mounting the controller in your
panel, make sure that the cut-out is of
the right size.
2-Check front panel gasket position
3-Insert the device through the cut-out.
If the mounting clamps are on the unit,
put out them before inserting the unit to
the panel.
During installation into a metal panel, care should be taken to avoid injury from
metal burrs which might be present. The equipment can loosen from vibration
and become dislodged if installation parts are not properly tightened. These
precautions for the safety of the person who does the panel mounting.
UV
Hz.
OFF AUTO
TEST
V
L31/L3N
V
L23/L2N
V
L12/L1N
PROG
TEST
RESET
G
G
EAOM-19
MAN.
START
MAN.
STOP
~
~
~
~
~
~
RPM
VV
FAILED
TOSTART
HIGH
TEMPERATURE
LOWOIL
PRESSURE
OVERSPEED
FAILURE
VOLTAGE
FAILURE
CHARGING
FAIL
VZ
BATT.VOLT.
FAILURE

EMKO EAOM-19 Specifications

General

Brand	EMKO
Model	EAOM-19
Category	Control Unit
Language	English