EMKO EAOM-19 - Accessing to the Technician Parameters

4.3 AccessingToTheTechnicianParameters
23
RESET
PROG
TEST
°F
VL12
GENV.
VL23
VL31
RESET
PROG
TEST
°F
VL12
GENV.
VL23
VL31
RESET
PROG
TEST
°F
VL12
GENV.
VL23
VL31
RESET
PROG
TEST
°F
VL12
GENV.
VL23
VL31
P00:MainsVoltage
ConnectionLevel
RESET
PROG
TEST
°F
VL12
GENV.
VL23
VL31
RESET
PROG
TEST
°F
VL12
GENV.
VL23
VL31
RESET
PROG
TEST
°F
VL12
GENV.
VL23
VL31
Not2: Usercanaccesstoall
parameters( ).P00toP29
TECHNICIANPASSWORD
Whenthebuttonis
pressedfor seconds,
passwordisaskedfor
accessingtoparameters.
5
Usercanaccesstotechnician
parametersbyenteringtechnician
password. Thisselectionisdonewith
incrementanddecrementbuttons.
PresstheEnterbutton.
Presstheincrement
button.
Enterpassword
withincrementand
decrementbuttons.
Not1: IfEnterbuttonispressed
andthetechnicianpasswordis
zero, screenisignored
and isshown.screen
PresstheEnterbuttonto
confirmpassword. Ifthe
passwordisincorrect,
theunitwilldropoutof
programmode.
Not3: When screenis
shown,parameterscanbe
seenbypressingEnterbutton
withoutenteringoperator
password.Butusercannot
changetheparameters.
Presstheincrementbuttonto
accesstotheparametervalue.
OperationScreen
Programmingcanbecarriedoutonlywhiletheunitisin mode.PresstheOFF(17)
button.Iftheengineisrunning,itwillstopandtheLED(6)lightson. Thenproceedasfollows:
OFF