EMKO EAOM-19 - 5 Commissioning; Manual Mode

5.Commissioning
31
1.Checkthattheunitiscorrectlywiredandthatthewiringisofastandardandrating
compatiblewiththesystem.
2.Checkthatthecorrectfusesarefitted.
3.Programtheunitasdetailedin
4. Taketemporarystepstopreventtheenginefromstarting.(forexample,disablethefuel
solenoid.)
5. Afteravisualinspectiontoensureitissafetoproceed,connectthebatterysupply.
6.OntheEAOM-19,presstheMANENGINESTART (14)button. AtthismomenttheLED(3)
lightson.
7.Checkthattheenginestartsequencecommences. Thestartermotorshouldrunforthe
programmedperiod(P16)forthepre-set(P06)numberoftimes.
8.Checkthatthe ( LED)flashesandtheLED(3)lightsoff.
9.ChecktheunitwillchangetotheSTOP positionandtheLED(8)lightson.
10.Restoretheenginetooperationalstate(reconnectthefuelsolenoid).
11.Pressthe (14)button. TheLED(3)willlighton.
12.Checkthestartsequence,asfollows:
thestartermotorruns
theenginestarts
thestartermotordisengagesoncetheengineisrunning.
Ifnot,checkthattheengineisfullyoperational(fuelavailableetc.)andcheckthewiringand
programmingoftheEAOM-19.
13.Checkthattheenginerunsuptoitsoperatingspeed.Ifnotandanalarmispresent,
checkthatthealarmisvalidandthenchecktheinputwiring.
14.Pressthe (20)button. AtthismomenttheLED(8)willlighton. The
engineshouldstop. Allowtimefortheenginetocometorest.
Section4.
StartFailure
MANENGINESTART
MANENGINESTOP
5.1ManualMode