To Next PageTo Next Page
Need help?Do you have a question about the EMKO TRANS-AMF and is the answer not in the manual?
General| Frequency | 50/60Hz |
|---|---|
| Communication | RS-485 |
| Display | LCD |
| Protection Class | IP20 |
| Output | Relay |
| Operating Temperature | -20°C to 70°C |
Key features and capabilities of the TRANS-AMF unit.
Diagram showing the three-phase connections for the TRANS-AMF unit.
Important guidelines and warnings for electrical connections.
Identification and explanation of components on the unit's front panel.
Detailed explanation of each button's operation and purpose.
Displays engine oil pressure, temperature, speed, and battery voltage.
Displays J1939 engine parameters like speed, oil pressure, and temperature.
More J1939 data including torque, boost pressure, and intake temperature.
Displays J1939 faults and input/output status.
Explanations of warning and alarm messages.
How to access and change operator-level settings.
Operator adjustable parameters related to mains voltage and frequency.
Operator adjustable parameters for generator voltage, frequency, current, and power.
Accessing and navigating technician-level settings.
Configuration for system network parameters like CT ratio and AC system type.
Settings for generator and mains breaker types and timings.
Technician adjustable parameters for generator voltage, frequency, and current protection.
Parameters for engine start sequence and crank disconnect conditions.
Settings for communication with the engine's ECU via CanBus.
Configuration and scaling for various sensor inputs.
Settings for configurable analog input types and values.
Settings for various configurable inputs (Conf. Input-1 to Conf. Input-7).
Settings for configurable outputs (Conf. Output-1 to Conf. Exp. Output-6).
Configuration of start and stop timers for various operations.
Settings for optional expansion modules like GSM, GPRS, Web Server.
Adjusting voltage and current offsets for mains and generator.
Adjusting offsets for sender inputs like oil pressure and temperature.
Steps to access and navigate different parameter groups.
Procedure for modifying and saving parameter values.
Operator adjustable settings for mains voltage trip points.
Operator adjustable settings for mains frequency trip points.
Operator adjustable settings for generator voltage protection.
Operator adjustable settings for generator frequency protection.
Operator adjustable settings for generator current protection.
Operator adjustable settings for generator power protection.
Configuration of communication parameters like baud rate and parity.
Configuration for mains failure detection and return delay.
Settings for generator under/over current protection and actions.
Configuration for short circuit and earth fault protection.
Configuration for audible alarms, start attempts, and cranking times.
Configuration for Baud rate, ECU type, and device address.
How to select the J1939 ECU type for communication.
Explanations for various error messages related to system and generator.
Detailed explanations for specific error messages.
Explanations for pressure, speed, and power-related errors.
Details on equipment use, housing, mounting, and protection.
Operating conditions, voltage, frequency, and measurement accuracies.
Details on inputs, outputs, expansion modules, and communication interfaces.
