EMKO TRANS-AMF - Configurable Input-7 Settings; Input-7 Configuration Options; Input-7 Active Delay and Cabin Temperature

59
Note: dis = disable
Min
Default
Unit
CONF. INPUT-7 (Inputs->Conf. input-7)
Max
30(dis)
10
4
20
0
2500
Sec
0
Input type
Polarity
Indication
Activation
Select from list
Active delay
0- Disable
1- User Configured (Digital)
2- Select From List (Digital)
3- Cabin Temperature (Anolog)
If Input Type is Digital
0- Normally Open (Close To Activate)
1- Normally Close (Open To Activate)
If Input Type is User Configured
0- Status
1- Warning Non-Latching
2- Warning Latching
3- Electrical Trip
4- Shutdown
If Input Type is User Configured
0- Active From Starting
1- Active From Safety On
2- Always Active
Input active delay (If Input Type is Digital)
If Input Type is Select From List
0-Remote Start On Load
1-Remote Start Off Load
2-Auxiliary Mains Fail
3-Simulate Lamp Test Button
4-Simulate Horn Reset Button
5-Simulate Alarm Reset Button
6-Simulate Auto Button
7-Simulate Test Button
8-Simulate Manual Button
9-Simulate Start Button
10-Simulate Stop Button
11-Generator Closed Auxiliary
12-Generator Load Inhibit
13-Mains Closed Auxiliary
14-Mains Load Inhibit
15-Auto Restore Inhibit
16-Auto Start Inhibit
17-Panel Lock
18-Scheduled Runs(Exercise) Inhibited
19-Priority Select
20-Transfer To Generator/Open Mains
21-Transfer To Mains/Open Generator
22-Remote Inhibit
23-Being Found Alive
24-Low Battery
3
Cabin temp.low prealr
Cabin temp.low reset
Cabin temp.low shutd.
Cabin temp.high preal
Cabin temp.high reset
Cabin temp.high shutd
5
Cabin temperature low prealarm
Cabin temperature low prealarm reset
Cabin temperature low shutdown
Cabin temperature high prealarm reset
Cabin temperature high prealarm
Cabin temperature high shutdown
100
100
100
100
100
100
ºC
ºC
ºC
ºC
ºC
ºC
dis
0
dis
dis
0
dis
-50(dis)
-50
-50(dis)
-50(dis)
-50
-50(dis)
0
0
2
24 8