EMKO EAOM-19 - 3. Electrical Connections; 3.1 Terminal Layout and Connection Instructions

13
You must ensure that the unit is correctly configured for your application.
Incorrect configuration could result in damage to the process being controlled,
and/or personal injury. It is your responsibility, as the installer, to ensure that
the configuration is correct.
Parameters of the unit has factory default values. These parameters must be
set according to the system’s needs.
Only qualified personnel and technicians trained specially should work on this
equipment. This equipment contains internal circuits with voltage dangerous
to human life. There is severe danger for human life in the case of unauthorized
intervention.
Be sure to use the rated power supply voltage to protect the unit against
damage and to prevent failure.
Keep the power off until all of the wiring is completed so that electric shock and
trouble with the unit can be prevented.
3.ElectricalConnections
3.1TerminalLayoutandConnectionInstructions
c
c
c
c
8pieces
1 2 3 4 5 6 7 8 9 10 11
12 13 14 15 16 17 18 19
11pieces
5.08mm
* * * * * * * *
*
7.62mm
Screwdriver0.8x3mm
Torque 0.5 Nm