EMKO EAOM-19 - Installation Fixing Clamp; Removing from the Panel

12
2.6InstallationFixingClamp
2.7RemovingfromthePanel
c
1
2
Montage of the device to a system must be done with it’s own fixing clamps. Do
not do the montage of the device with inappropriate fixing clamps. Be sure that
device will not fall while doing the montage.
The unit is designed for panel
mounting.
1-Insert the unit in the panel cut-out
from the front.
2-Insert the mounting clamp from the
rear side of the device and tighten the
fixing screws to secure the unit
against the panel.
c
3
1
2
Before starting to remove the device from panel, power off the device and the
related system.
1-Loosen screws.
2-Lift the locking tabs located on both
the right and left hand sides and pull
the fixing clamp from the device while
holding the unit in place.
3-Pull the unit through the front of the
panel
UV
Hz.
OFF AUTO
TEST
V
L31/L3N
V
L23/L2N
V
L12/L1N
PROG
TEST
RESET
G
G
EAOM-19
MAN.
START
MAN.
STOP
~
~
~
~
~
~
RPM
VV
FAILED
TOSTART
HIGH
TEMPERATURE
LOWOIL
PRESSURE
OVERSPEED
FAILURE
VOLTAGE
FAILURE
CHARGING
FAIL
VZ
BATT.VOLT.
FAILURE
UV
Hz.
OFF
AUTO
TEST
V
L31/L3N
V
L23/L2N
V
L12/L1N
PROG
TEST
RESET
G
G
EAOM-19
MAN.
START
MAN.
STOP
~
~
~
~
~
~
RPM
VV
FAILED
TOSTART
HIGH
TEMPERATURE
LOWOIL
PRESSURE
OVERSPEED
FAILURE
VOLTAGE
FAILURE
CHARGING
FAIL
VZ
BATT.VOLT.
FAILURE