EAOM-210 FLJ.eng / ver 0.0
Pages 107 / 132
Click “Comport Setting” in Setting menu. Then Comport Settings window is monitored.
And then change Comport Settings, Slave ID parameters and click OK button.
Note: The value of above mentioned ‘Port’ must be the same as the Port No in the
Ethernet module on the unit.
Disconnect: If the connection is established over modem or RS-232 port, connection can
be cut off with this selection.
Auto Calling: The PC software will be done auto calling to the all registered locations via
Ethernet or Dial-up modem. Adjust the auto calling time please following steps;
Auto Calling Enable: The auto calling feature is selected as active or passive.
Help Menu
Help: This menu allows the user to get information about mention to used the program and
the menus in the program.
About: Click “About” in Help menu. It gives information about the PC software version and
MCU software version to the user.
To Next Page
Loading...
