EMKO EAOM-210 FLJ - Section 1 Introduction

EAOM-210 FLJ.eng / ver 0.0
Pages 4 / 132
Section 1 Introduction
The EAOM-210 FLJ provides for automatic transfer of a load from mains to generator in the
event of a mains failure. Intended for unattended operation, it is able to detect failure of
any phase of the mains and to start and switch over to a generator if the mains voltage
goes outside pre-set limits. Both automatic and manual control is possible. A test mode is
also available which allows the generator to be run without taking the load.
The unit monitors J1939 ECU messages and provides remote start/stop control via J1939
protocol (supported ECUs: Volvo EMS2, Volvo EDC4, Perkins and standard messages)
The unit sends alarm information to pre-defined GSM number via GSM modem.
The user may control the device, failure reset, change working mode, engine start, engine
stop, access the parameters of device, change the parameters and enquire information
about generator’s active status by sending and receiving SMS.
The unit enables continuous communication with build in ethernet and dial-up modem
facility. EAOM-210FLJ PC software offers remote control & visualisation and maintenance
management multiple Gen-Sets from a central computer via internet or local ethernet
network. Software also observes for alarms and archieves them. The failures and alarms
traced by EAOM-210FLJ PC software can be sent to 3 GSM numbers pre-defined in software
for your information.
The unit monitors generator operation and gives warning of any faults that are detected.
The unit monitors:
• Engine speed
• Engine Oil pressure
• Coolant temperature
• Fuel Level
• Battery voltage
• Charge generator voltage
• Engine run time
• Number of starts
• Next maintenance
• Number of engine runs
• Mains volts (L1-N, L2-N, L3-N)
• Mains volts (L1-L2, L2-L3, L3-L1)
• Mains phase-phase average volt
• Mains phase-neutral average volt
• Mains Hz
• Generator volts (L1-N, L2-N, L3-N)
• Generator volts (L1-L2, L2-L3, L3-L1)
• Generator phase-phase average volt
• Generator phase-neutral average volt
• Generator Hz
• Generator apparent power S1 (kVA)
• Generator apparent power S2 (kVA)
• Generator apparent power S3 (kVA)
• Generator total apparent power (kVA)
• Generator active power P1 (kW)