EMKO EAOM-210 FLJ - 3.4 Accessing Technician Parameters

EAOM-210 FLJ.eng / ver 0.0
Pages 24 / 132
3.4 Accessing to the Technician Parameters
TECHNICIAN SECTION
PROG
Operation Screen
When the prog button is
pressed, password is
asked for accessing to
parameters.
PROG
OPERATOR SECTION
PROG
TECHNICIAN PASSWORD
Press the Enter button to
confirm password. If the
password is incorrect, the
unit will drop out of
program mode.
TECHNICIAN SECTION
PASSWORD
162
PROG
User can access to technician parameters
by entering technician password. This
selection is done with increment and
decrement buttons.
Press the Enter button.
TECHNICIAN SECTION
PASSWORD
0
PROG
Enter password with
increment and
decrement buttons.
Note1: If Enter button is pressed
and the technician password is
zero, Password screen is ignored.
TECHNICIAN SECTION
GEN.CUR/POW.ACT.PAGE
PROG
Note2: When Password
message is shown, parameters
can be seen by pressing Enter
button without entering
password. But user can not
change the parameters.
technician
GENERATOR CURRENT/POWER
ACTIONS Page
TECHNICIAN SECTION
MISCELLANEOUS PAGE
PROG
Technician
can access to the
following page by pressing
increment button
Technician
can access to the
following page by pressing
increment button
MISCELLANEOUS Page
Operator can not
access to this page.
Operator can not
access to this page.
MAINS & LOAD
L12: 380Vac I1: 126A
Fq:50.0Hz
AUTO
L23: 380Vac I2: 126A
L31: 380Vac I3: 126A
IT: 378A
IEA: 63A
CRANKNG ATTEMP
OVER SPEED PREALARM!