EMKO EAOM-210 FLJ - 3.6 PC Interface Configuration

EAOM-210 FLJ.eng / ver 0.0
Pages 94 / 132
3.6 Pc Interface
The PC interface kit (PCIK) comprises the following:
9 pin D connector/FCC68(4 pin) connection lead with 2 meters cable
EAOM-210 FLJ configuration software (CD)
3.6.1 Technical Specifications
RS-232 serial communication with Modbus ASCII protocol
Baud Rate from 1200 to 19200
8 data bits, Parity; None, Odd or Even, Stop Bit; 0 or 1
Maximum allowable cable length is 10 meters
3.6.2 RS-232 Serial Interface, Programming The Device Over PC or Modem
3.6.2.1 Cable Connection Between RS-232 Terminal of the Device and PC
9 pin D connector
female
PC
9 pin D connector
male
RX TX GND
3.6.3 Installation Instruction
3.6.3.1 Minimum system requirements
Processor :486 66MHz
Operating Systems :Windows95/98, Windows NT
Ram :16 Mbyte
Monitor :14” SVGA (640x480 resolution)
Fixed Disk Free Space :1 Mbyte
Disk Drive :CD-ROM
Communication :An RS232 communication port is needed to
communicate with the EAOM-210 FLJ Unit
3.6.3.2 Installing EAOM-210 FLJ configuration software
Insert the software CD into the CD-ROM drive on the PC
Double click on MyComputer
Then double click on CD-ROM drive
There will be a short delay while the CD-ROM is accessed, then the disk contents will be
displayed.
Double click on “Install.exe”.
EAOM-210 FLJ configuration software will be installed automatically on to your PC in its
own folder(directory). It will also create “START MENU” items.