EMKO EAOM-210 FLJ - Changing and Saving Operator Parameter Values

EAOM-210 FLJ.eng / ver 0.0
Pages 22 / 132
3.3.1 Changing and Saving Operator Parameter Values
Example-1 : To change Mains Under Voltage parameter in ”MAINS LEVELS PAGE”, user must
access to “MAINS LEVELS PAGE” page firstly.
OPERATOR SECTION
PASSWORD
0
PROG
Operation Screen
OPERATOR PASSWORD
When the prog button is
pressed, password is
asked for accessing to
parameters.
User can access to operator parameters by
entering operator or technician password.
This selection is done with increment and
decrement buttons.
Enter
password with
increment and
decrement
buttons.
Press the Enter button to
confirm password. If the
password is incorrect, the
unit will drop out of
program mode.
Operator and technician
can access to this page.
MAINS LEVELS Page
PROG
OPERATOR SECTION
PROG
OPERATOR SECTION
PASSWORD
161
PROG
OPERATOR SECTION
MAINS LEVELS PAGE
PROG
OPERATOR SECTION
MAINS LEVELS PAGE
MAINS UNDER VOLTAGE
Vac 320
PROG
Press Enter button to access
to first parameter in Mains
Levels page.
Mains Under Voltage parameter
Parameter can be changed with
increment and decrement buttons
OPERATOR SECTION
MAINS LEVELS PAGE
MAINS UNDER VOLTAGE
Vac 322
PROG
Press Enter button to confirm the
changed value and access to the
following parameter.
Note1: If Enter button is
pressed and the operator
password is zero, Password
screen is ignored.
MAINS & LOAD
L12: 380Vac I1: 126A
Fq:50.0Hz
AUTO
L23: 380Vac I2: 126A
L31: 380Vac I3: 126A
IT: 378A
IEA: 63A
CRANKNG ATTEMP
OVER SPEED PREALARM!