EAOM-210 FLJ.eng / ver 0.0
Pages 80 / 132
44 GENERATOR HIGH FREQUENCY PRE-ALARM
This output indicates that a generator high frequency warning (pre-alarm) has occurred.
45 GENERATOR HIGH FREQUENCY SHUTDOWN
This output indicates that a generator high frequency shutdown has occurred.
46 GENERATOR HIGH VOLTAGE PRE-ALARM
This output indicates that a generator high voltage warning (pre-alarm) has occurred.
47 GENERATOR HIGH VOLTAGE SHUTDOWN
This output indicates that a generator high voltage shutdown has occurred.
48 GENERATOR LOAD INHIBIT
This output indicates that a digital input has been configured as ‘generator load inhibit’ is
active.
49 GENERATOR LOW FREQUENCY PRE-ALARM
This output indicates that a generator low frequency warning (pre-alarm) has occurred.
50 GENERATOR LOW FREQUENCY SHUTDOWN
This output indicates that a generator low frequency shutdown has occurred.
51 GENERATOR LOW VOLTAGE PRE-ALARM
This output indicates that a generator low voltage warning (pre-alarm) has occurred.
52 GENERATOR LOW VOLTAGE SHUTDOWN
This output indicates that a generator low voltage shutdown has occurred.
53 RESERVED
54 GENERATOR STOPPING
This output source indicates that the engine has been instructed to stop but has not come to
rest.
55 HORN OUTPUT
This output indicates that the horn alarm has occurred.
56 LAMP TEST
This output indicates that the module is performing a lamp test. Once the lamp test
completed, the output will become inactive again. The output can be used to feed a lamp test
on external modules or panel lamps.
57 LEVEL PREALARM
This output indicates that a level warning (pre-alarm) has occurred.
58 LOSS OF MAGNETIC PICK-UP SPEED SIGNAL
This output indicates that the magnetic pick up signal is not sufficient to be used by the
module for speed monitoring. The alarm can only operate if the speed signal fails to appear
during cranking. It is disabled if ‘multiple attempts to engage’ is selected. If the MPU fails
during engine running this would result in an underspeed alarm.
59 MAINTENANCE DUE ALARM
This output indicates that the generator is now due for maintenance either because it has
used all the available running hours or the periodic maintenance time has expired. To clear
the output a maintenance reset must be performed.
To Next Page
Loading...
