EMKO EAOM-210 FLJ - Page 91

EAOM-210 FLJ.eng / ver 0.0
Pages 91 / 132
(CONFIG. LED-123 PAGE) LED-1,2,3 CONFIGURATION page
LED-1 FUNCTION
LED-1 function can be configurable to
simulate one of the conf. Inputs or error
messages:
0- Led not used
1- Conf. Input-1 error or status active
2- Conf. Input-2 error or status active
3- Conf. Input-3 error or status active
4- Conf. Input-4 error or status active
5- Conf. Input-5 error or status active
6- Conf. Input-6 error or status active
7- Exp. conf. Input-1 error or status active
8- Exp. conf. Input-2 error or status active
9- Exp. conf. Input-3 error or status active
10- Exp. conf. Input-4 error or status active
11- Exp. conf. Input-5 error or status active
12- Exp. conf. Input-6 error or status active
13- Exp. conf. Input-7 error or status active
14- Exp. conf. Input-8 error or status active
15- Emergency stop
16- Over speed error
17- Under speed error
18- Over speed prealarm
19- Under speed prealarm
20- Multiple engage fail
21- Speed loss error
22- Generator stop error
23- Level error
24- Battery low error
25- Battery high error
26- Temp prealarm
27- Level prealarm
28- Pressure prealarm
29- Generator Under Voltage prealarm
30- Generator Over Voltage prealarm
31- Generator Under Frequency prealarm
32- Generator Over Frequency prealarm
33- Maintenance error
34- Generator Breaker Not Closed alarm
35- Generator Breaker Not Opened alarm
36- Mains Breaker Not Closed alarm
37- Mains Breaker Not Opened alarm
38- Over Current Error
39- Short Circuit Error
40- Earth Fault Error
41- J1939 Amber warning lamp error
42- Over Current Warning
43- Short Circuit Warning
44- Earth Fault Warning
45- J1939 Red stop lamp error
46- Over Current Electrical Trip
47- Short Circuit Electrical Trip
48- Earth Fault Electrical Trip
49- Can Bus error
(dis)0 - 49 1
LED-2 FUNCTION Same as the LED-1 function
0 - 49 2
LED-3 FUNCTION Same as the LED-1 function
0 - 49 3