Emotron M20 - Page 25

CG Drives & Automation 01-5958-01r0
Programming
1. Go to window 01.
2. Press and hold and simultaneously for 3 seconds.
3. The next unit of measurement is set and appears for 2 sec (see examples).
Repeat to select the desired measurement unit according to the table.
* Measured shaft power as % of rated power.
RESET
RESET
12
01
%%
kW
4.62
01
kW
kW
12
01
%
HP
%
3.52
01
HP
:
absolute value
:
relative value*
:
absolute value
:
relative value*
(default)
For 2 seconds Read-out example