28
AirFlow
®
S1
Replacement of the electrovalve
Remove the two screws (63) and the washers (26).
Release the plate support (21) of the electrovalve and re-
move the two plastic screws (20).
Disconnect the three electrical connectors from the elec-
trovalve.
Disconnect the four uniclamps (92) and the yellow air hoses
(66) from the electrovalve (23).
Put on a new electrovalve in replacement.
Place the seal (included with the electrovalve set)
between the electrovalve and the plate support.
92 66 20
21
63 26
Seal
23
To Next Page
Loading...
