Need help?Do you have a question about the Endace DAG 9.2X2 and is the answer not in the manual?
General| Maximum Packet Capture Rate | 20 Gbps |
|---|---|
| Memory | 8 GB |
| Hardware Timestamping | Yes |
| Form Factor | PCIe |
| Supported Protocols | Ethernet, IPv4, IPv6 |
| Operating System Support | Linux |
| Ports | 2 x 10 GbE SFP+ |
| Bus Interface | PCI Express Gen3 x8 |
Guides on installing DAG software and selecting a PCIe slot.
Step-by-step instructions for physically installing the DAG card.
Covers FPGA setup, firmware selection, loading, programming, and `dagrom`.
Explains `dagconfig` tokens and options for card setup.
Introduces data capture and basic capture utilities like `dagsnap`.
Discusses high-speed capture, packet drops, and buffer management.
Covers external references, testing signals, and sync scenarios.
Guides on calculating buffer size based on burst duration and latency.
Details on using support scripts and required information.
To Next Page