Endace DAG 9.2X2 - Reset; Rx and Tx Streams; Rxonly; Rxtx

To Next Page

To Previous Page

EDM01-36v10 DAG_9.2X2_Card_User_Guide - Configuring the DAG card

reset

Resets the ethernet framers, set auto mode.

Example

dagconfig -d0 reset

rx and tx Streams

Indicates the number of rx and tx streams are available on the DAG card. Not configurable.

Stream information relates to the setting of mem (page 29

rxonly

Configures the memory hole to receive only.

Example

dagconfig rxonly

rxtx

Enables both transmit and receive, and splits the memory hole for rx and tx.

This allocates 16MB of memory to each transmit stream, and divides the remaining memory between the

receive streams.

Example

dagconfig rxtx

Note:

This option is only applicable on firmware images containing TX.

stream_drop_count

Details the number of packets dropped during current capture session on this stream.

Example

Stream 0: stream_drop_count = 0

Stream 2: stream_drop_count = 0

...

terf_strip16/terf_strip32/noterf_strip

Strips the CRC value (32 bits) from the packet or sends packet “as is” (noterf_strip). The TERF line in

the current configuration indicates the current TERF option.

Note:

Only displayed if the DAG card supports transmit (i.e. has a TERF image).

Example

dagconfig terf_strip32

dagconfig noterf_strip