Endress+Hauser Analytik Jena Multi X 2500 - Fig. 2 Front View with Status LED; Fig. 3 Rear View Multi X 2500

multi X 2500 Function and layout of the multi X 2500
19
Fig. 2 Front view with status LED
The mains connection with mains switch and the interfaces for connecting the system
components are located on the rear of the device.
The computer is connected via a USB port. The interfaces for connecting the
autosampler and the detector module are RS 232 ports.
Fig. 3 Rear view multi X 2500
1 Interfaces (see Fig. 4)
2
PC connection via USB
3 Mains connection, equipment switch
The equipment fuse and the mains connection are located below the device's mains
switch. The rating plate is also attached there.
Mains connection and
interfaces