Need help?Do you have a question about the Endress+Hauser Analytik Jena multi EA 5000 and is the answer not in the manual?
General| Combustion Method | Horizontal and vertical combustion |
|---|---|
| Elements Measured | Carbon (C), Sulfur (S), Nitrogen (N), Chlorine (Cl) |
| Sample Types | Solids, liquids, gases |
| Automation | Optional autosampler |
| Analytical Principle | Combustion analysis |
| Analysis Time | 2 to 10 minutes per sample |
| Carrier Gas | Helium or argon |
| Oxygen Supply | Pure Oxygen |
| Calibration | Multi-point calibration |
| Software | MultiWin software |
| Interfaces | Ethernet, USB |
| Power Requirements | 230 V / 50-60 Hz |
| Dimensions (W x D x H) | 650 mm x 600 mm x 600 mm |
| Applications | Elemental analysis of organic and inorganic materials |
Identifies and explains warning and mandatory action labels on the device.
General safety precautions and checks before and during device operation.
Emergency procedures for immediate shutdown and safety measures.
Describes the core components and capabilities of the basic analysis module.
Explains the fundamental operating mechanisms and modes of the analyzer.
Lists and describes the primary hardware components of the basic module.
Details the electrical power requirements and safety precautions.
Outlines responsibilities and requirements for connecting gas supplies.
Step-by-step instructions for setting up and starting the analysis system.
Provides essential guidelines for performing measurements with different modules.
Guides the user in choosing the appropriate analysis method based on sample type.
Step-by-step procedure for powering up the system components.
Explains the operational principles and structural components of the CLD 5000 detector.
Provides instructions for installing the nitrogen detector module and its absorber.
Step-by-step guide for operating the nitrogen analysis system.
Provides guidance on fault analysis and log file recording for troubleshooting.
Addresses communication issues and software error messages.
Lists common device faults for the basic module and their remedies.
Provides a summary of routine maintenance tasks for the basic module and CLD 5000.
Details the procedures for maintaining the combustion tube.
Details maintenance procedures for the CLD 5000 detector.
Details maintenance procedures for the Cl module.
Safety instructions and precautions to avoid damage during device transport.
Steps for preparing the basic module before transport or long-term storage.
Detailed technical specifications for the multi EA 5000 basic module.
Technical specifications for the CLD 5000 nitrogen detector.
Technical specifications for the Cl module.
Technical specifications for the UVFD 5000 and MPO 5000 sulfur detectors.
To Next Page