Endress+Hauser Analytik Jena Multi X 2500 - Fig. 4 Electrical Interfaces on the Rear of the Multi X 2500; Fig. 5 Device Control and Interfaces in the Device Interior

Function and layout of the multi X 2500 multi X 2500
20
Fig. 4 Electrical interfaces on the rear of the multi X 2500
1 USB connection to the control PC
2
External connection (to the pre-combustion adapter)
3
Auto-injector connection
4
Flame sensor connection (to the ABD)
5 Connection Cl module
6
Connection TOC module
7
Connection sampler (RS 232 bus)
8
Connection service
The control electronics are on the right-hand side of the rear panel of the basic device
behind the cover. The internal device control is used for power supply, controlling the
individual components of the basic device and the communication with the computer
and other connected system modules.
The electrical connections of the combustion furnace, the flame sensor and the
thermocouple are located right under the control electronics' cover. The connections
are only accessible in the vertical installation position of the combustion furnace.
Fig. 5 Device control and interfaces in the device interior
1 Control electronics (behind the cover)
2
Marking interfaces
3
Interface manual boat feeder MBD
4
Interface thermocouple
5 Interface combustion furnace
6
Interface flame sensor (optional, in horizontal
operation with ABD)
Device control, interfaces
in the device