Endress+Hauser Cerabar M PMC45 - Repair

Troubleshooting Cerabar M HART
38 Endress+Hauser
Table of parameters that can be reset by the reset code numbers.
8.6 Repair
The Endress+Hauser repair concept provides for measuring devices to have a modular design and
that the customer may also carry out repairs.
The "Spare parts" section contains all the spare parts, and their order numbers, which you can order
from Endress+Hauser to repair the Cerabar M. Where necessary, the spare parts also include
replacement instructions.
!
Note!
• For certified devices, please refer to the "Repair of Ex-certified devices" section.
• For more information on service and spare parts contact Endress+Hauser Service.
→ See www.endress.com/worldwide.
• Only the process connection on the PMC41 can be
exchanged by the customer. For all other models, a device without a display and housing can be
ordered. → See Technical Information TI399P, "Ordering information" section.
H0 H1 H2 H3 H4 H5 H6 H7 H8 H9
V0
5140
2380
2509
731
Measured
value
Set
4 mA
= V7H6
= V7H6
= V7H6
Set
20 mA
= V7H7
= V7H7
= V7H7
4 mA
automat.
deleted
deleted
deleted
20 mA
automat.
deleted
deleted
deleted
Set
bias pres-
sure
0.0
0.0
0.0
Bias pres-
sure
automat.
deleted
deleted
deleted
Output
damping
0.0
0.0
0.0
Select
safety
max.
max.
max.
Pressure
unit
bar
V2
5140
2380
2509
731
Diagnostic
code
Last
diag. code
0
0
Software
no.
V3 to V6
V7
5140
2380
2509
731
Current
display
Simulation
Off
Simulate
current
deleted
Current
min. 4 mA
Off
Off
Off
Low Sen.
Calibration
= V7H6
= V7H6
High Sen.
Calibration
= V7H7
= V7H7
Lower
Measuring
Limit
Upper
Measuring
Limit
Sensor
Pressure
V8
V9
5140
2380
2509
731
Pressure
before
bias corr.
Security
locking
130
VA
5140
2380
2509
731
Measuring
point
deleted
deleted
System ID
deleted
deleted
User text
deleted
Serial
number
Serial No.
Sensor