Cerabar M HART Technical data
Endress+Hauser 41
8.9 Return
Before you send in a device for repair or inspection, perform the following:
• Remove all traces of the fluid. Pay special attention to the grooves for seals and crevices which
could contain fluid residues. This is especially important if the fluid is hazardous to health. Please
refer also to the "Declaration of Hazardous Material and Decontamination".
Please enclose the following when returning the device:
• The duly completed and signed "Declaration of Hazardous Material and Decontamination".
Only then can Endress+Hauser inspect or repair the returned device.
• The chemical and physical properties of the fluid.
• A description of the application.
• A description of the error which occurred.
• Special instructions on handling, if necessary, e.g. safety data sheet as per EN 91/155/EEC.
8.10 Disposal
When disposing, separate and recycle the device components based on the materials.
8.11 Software history
9 Technical data
For technical data, please refer to the Technical Information TI399P for Cerabar M.
Date Software version Changes to software Operating Instructions
04.1999 1.0 Original software.
Compatible with:
– Commuwin II
– HART Communicator 375
– FieldCare
–AMS
–PDM
BA201P/00/en/05.99
52002513
02.2001/
02.2002
1.1/1.2 Reset onsite of Upper-range value, Lower-
range value, bias pressure/Adjusted for OEM
manufacturers
BA201P/00/en/04.02
52013871
BA201P/00/en/11.03
52013871
BA201P/00/en/12.03
52022183
BA201P/00/en/06.08
71064502
To Next Page
Loading...
