Basic safety instructions Cerabar M PMC51, PMP51, PMP55
6 Endress+Hauser
1.4 Turn down calculation
See the Operating Instructions.
1.5 Registered trademarks
• KALREZ®
Registered label of E.I. Du Pont de Nemours & Co., Wilmington, USA
• TRI-CLAMP®
Registered label of Ladish & Co., Inc., Kenosha, USA
•
Registered trademark of the IO-Link Community.
• GORE-TEX® trademark of W.L. Gore & Associates, Inc., USA
2 Basic safety instructions
2.1 Requirements for personnel
Personnel must meet the following requirements for their tasks:
‣
Trained, qualified specialists must have a relevant qualification for this specific function
and task
‣
Are authorized by the plant owner/operator
‣
Are familiar with federal/national regulations
‣
Before starting work, read and understand the instructions in the manual and
supplementary documentation as well as the certificates (depending on the application)
‣
Follow instructions and comply with basic conditions
2.2 Designated use
The Cerabar M is a pressure transmitter for measuring level and pressure.
2.2.1 Incorrect use
The manufacturer is not liable for damage caused by improper or non-designated use.
Verification for borderline cases:
‣
For special fluids and fluids for cleaning, Endress+Hauser is glad to provide assistance in
verifying the corrosion resistance of fluid-wetted materials, but does not accept any
warranty or liability.
2.3 Workplace safety
For work on and with the device:
‣
Wear the required personal protective equipment according to federal/national
regulations.
‣
Switch off the supply voltage before connecting the device.
To Next Page
Loading...
