Endress+Hauser iTEMP TMT142B - Page 13

iTEMP TMT142B Mounting
Endress+Hauser 13
7. Screw the cable gland tight as described in the Ensuring the degree of protection
section. The cable gland must meet explosion protection requirements. →  20
4.2.2 Remote mounting
NOTICE
Do not over tighten the mounting screws of the 2" pipe mounting bracket in order to
prevent any damage.
‣
Maximum torque = 6 Nm (4.43 lbf ft)
121 (4.8)
121 (4.8)
!6.4(0.25)
121 (4.8)
121 (4.8)
!6.4(0.25)
WR10
M6
A0007952
 2 Mounting of the field transmitter via direct wall mounting or with a 2" pipe mounting bracket (316L,
available as an accessory). Dimensions in mm (in)