iTEMP TMT142B Operating menu and parameter description
Endress+Hauser 83
Description Use this function to define the HART address of the device.
It is not possible to write to the parameter. The HART address can be set in FDT/
DTM-based operating tools, via the CommDTM.
1)
1) It cannot be set via the Configuration app, however.
Factory setting 0
Additional information The measured value can only be transmitted via the current value if the address is set to
"0". The current is fixed at 4.0 mA for all other addresses (Multidrop mode).
No. of preambles
Navigation Application → HART configuration → No. of preambles
Description Use this function to define the number of preambles in the HART telegram.
User entry 5 to 20
Factory setting 5
14.3 Menu: System
14.3.1 Submenu: Device management
HART short tag
Navigation System → Device management → HART short tag
Description Use this function to define a short tag for the measuring point.
User entry Up to 8 alphanumeric characters (letters, numbers and certain special characters).
Factory setting TMT142B
Device tag
Navigation System → Device management → Device tag
Description Use this function to enter a unique name for the measuring point so it can be identified
quickly within the plant.
User entry Up to 32 alphanumeric characters (letters, numbers and certain special characters).
To Next Page
Loading...
