Endress+Hauser iTEMP TMT142B - Display mounting; Post-installation check

Mounting iTEMP TMT142B
14 Endress+Hauser
4.3 Display mounting
1
2
3
4
90°
90°
90°
90°
3 mm
A0041863
 3 4 display installation positions, attachable in 90° stages
1 Cover clamp
2 Housing cover with O-ring
3 Display with fitting kit and twist protection
4 Electronics module
1. Remove the cover clamp (1).
2. Unscrew the housing cover together with the O-ring (2).
3. Remove the display with twist protection (3) from the electronics module (4). Fit the
display with the fitting kit in the desired position in 90° stages and plug it into the
correct slot on the electronics module.
4. Clean the thread in the housing cover and housing base and lubricate if necessary.
(Recommended lubricant: Klüber Syntheso Glep 1)
5. Then screw the housing cover together with the O-ring.
6. Fit the cover clamp (1) back on.
4.4 Post-installation check
After installing the device, carry out the following checks:
Device condition and specifications Notes
Is the device undamaged (visual inspection)? -
Do the ambient conditions match the device specification (e.g. ambient temperature,
measuring range, etc.)?
→  47